Weight not to exceed 5,500 (+-100) lbs

Drawbar Height 22 inches

1.   Motor must match pickup make.

2.  OEM fuel systems only.  EFI allowed, factory cast (OEM) heads only.

3.  No weight bars on front.  Vehicle must have front bumper, and weight added must be in the pickup box.

4.  No solid or blocked suspension or ladder bars.  Must be on springs.  Lift kits allowed.  Must use stock frame and running gear.

5.  Must pull from rear bumper or trailer hitch.

6.  Must be licensed and insured.  No class jumping allowed (1 ton may pull in 3/4 ton)

7.  480 cubic inch limit*  Dual plane intake only, no air gap type intake manifolds allowed.  Roller rockers are acceptable.  Engine must create 15" Hg vacuum or greater at 1200 RPM.  No carburetor spacers allowed.

     * An exception to this rule is if vehicle was originally equipped with a GM 8.1 liter or
         Dodge 8.0 liter engine these will be allowed.

8.  Vehicles must run pump gas.

9.  Vehicles must have a full-length exhaust system with muffler(s), 3" diameter max.  Headers are allowed, but must be inside of frame rails.

10. No Profab-type transmission conversions allowed.

11. Vehicle must have DOT approved tires, no larger then 33 inch.

12. No truck may hook in two different divisions at the same event.

13.  Under age drivers (under 18) must have signed parental authorization/release form before pulling.

14. All General Track Rules will apply. (see tractor pull page)

Safety Equipment Required

1.   Water pump may be used.  Harmonic balancer must be bolted on.

2.   Drive shaft loops recommended on U joint next to housing minimum thickness ¼-inch or 3/8-inch aluminum. 

3.   Drivers must wear lap seat belt and a DOT approved helmet.

Automatic transmissions must be protected from the back of the block to the rear of the planitaries, 360 degrees.